-
Injection Molding of Glass Filled Filter Component for the Automotive Industry
This glass filled nylon component is part of a filter housing assembly for an automotive fuel system. This part is molded in our all electric 200 ton Niigata machine.
Injection Molding of Thermoplastic Antenna for the Communications Industry
Plastic Design International (PDI) produces custom handheld housing that is almost 14 inches long with wall thickness of 0.055 inch. Antenna is made of aromatic polyester-base thermoplastic.
Over-Molding Handheld Antenna for the Defense Industry
Plastic Design International (PDI) produces custom over-molded handheld antenna that is 330 mm long with wall thickness of 1.60 mm. Antenna is made of aromatic polyester-base thermoplastic with shore hardness of 45D which is over molded over flexible steel wire & electronic circuit board .
Injection Molding of Pump Housing using Carbon & Glass Reinforced Polyamide
Designed for use on a power hydraulic filter, we recommended carbon and glass reinforced, heat-stabilized polyamide 6/6 as the material of construction due to its strength, dimensional stability and resistance to both heat and abrasion for this under-the-hood application.
Plastic Injection Molded Inner Chamber
For this high volume project, we worked closely with the customer in the fire protection industry to provide a value solution by integrating several assembly steps directly into the molding process.
